TAS-A; Skytrax 6xx-A How to test ADS-B Targets vs Regular TAS targets

            You can use the command interface to select what the displays will show.  The “targdisp” command selects what traffic is displayed; either ADS-B, TAS or Both.  At the command prompt you can use the following commands:

             

            Command

            Description

            help targdisp

            Show help for the targdisp command.

            targdisp

            Show current target display status.

            targdisp a

            Show only ADS-B traffic on the displays.

            targdisp t

            Show only TAS traffic on the displays.

            targdisp b

            Show both ADS-B and TAS traffic on the displays.

             

            Note that the targdisp setting is NOT stored between power cycles, so it doesn’t really matter if you forget to enable both ADS-B and TAS traffic before shutting down the unit.  It ALWAYS sets it to both ADS-B and TAS traffic upon power-up.


            Updated: 22 Aug 2018 10:47 AM
            Helpful?  
            Help us to make this article better
            0 0