.jpg)
TAS-A; Skytrax 6xx-A How to test ADS-B Targets vs Regular TAS targets
Feb 08, 2019
1059
You can use the command interface to select what the displays will show. The “targdisp” command selects what traffic is displayed; either ADS-B, TAS or Both. At the command prompt you can use the following commands:
|
Command |
Description |
|
help targdisp |
Show help for the targdisp command. |
|
targdisp |
Show current target display status. |
|
targdisp a |
Show only ADS-B traffic on the displays. |
|
targdisp t |
Show only TAS traffic on the displays. |
|
targdisp b |
Show both ADS-B and TAS traffic on the displays. |
Note that the targdisp setting is NOT stored between power cycles, so it doesn’t really matter if you forget to enable both ADS-B and TAS traffic before shutting down the unit. It ALWAYS sets it to both ADS-B and TAS traffic upon power-up.
