Starting with IFD4XX/5XX SW release 10.2.4.1 there is an option to "Password Protect" the configuration of the IFD in maintenance mode by setting a PIN which will prevent changing the configuration pages with the exception of the WiFi page and Bluetooth page. You can use the attached file to remove the pin. Once the…
The Following Interface Information is "FOR REFERENCE USE ONLY" and is not FAA Approved Data. Please see the applicable STC Installation manuals, or other Approved documentation for installation approval. IFD interface to JPI FS450
The Following Interface Information is "FOR REFERENCE USE ONLY" and is not FAA Approved Data. Please see the applicable STC Installation manuals, or other Approved documentation for installation approval. IFD Interface with E.I. FP-5L The interface between the IFD and FP-5L fuel computer. Depending on the age o…
The Following Interface Information is "FOR REFERENCE USE ONLY" and is not FAA Approved Data. Please see the applicable STC Installation manuals, or other Approved documentation for installation approval. IFD Interface with JPI EDM700/730/800/830
IFD Dimming setup tutorial There are several places in the IFD that dimming control settings will affect the behavior of the backlighting and bezel lights. The 1st place to understand is in normal flight mode, accessible by the pilot, on the "Aux" > "Setup" > "User Options" page, shown below. For both "Bez…
IFD540/440 VHF Weak Tx or Rx If the VHF seems to operate fine on start-up, but gradually get worse over time, it may be a sign that the IFD has inadequate cooling. You can always download the logs from the IFD in question and email them to techsupport@avidyne.com , along with a brief synopsis. If internal tempe…
The Following Interface Information is "FOR REFERENCE USE ONLY" and is not FAA Approved Data. Please see the applicable STC Installation manuals, or other Approved documentation for installation approval. In installations with dual IFDs, the #1 IFD is the "master" and the #2 IFD is the "slave," though data is share…
You'll want to go to the "Aux" page group, then go to the "System" tab. From there you will see a "Status" button on the lower left side of the display. It defaults to "Status - Software". You'll want to cycle that key until it shows "Status - GPS". This is also where you can find your datalink status (by…