Dealer Article - IFD 5XX 4XX Software Update 10.3.3.2 Update & Instructional Video For Loading
Click here to request 10.3.3.2 Software
IFD 5XX/4XX Software Version 10.3.3.2 introduces improvements to the following in AviOS10.3.3.2:
Bug Fixes
- Fixed CAS alerting
- Some messages would remain displayed even after being acknowledged (in a dual-IFD configuration)
- Disabled syncing of Switch Tanks between connected IFDs
- Prevented "Stuck Mic" alert on one IFD from being displayed on a connected IFD
- Inhibited ARS messages being sent from the IFD to Vantage
- Fixed NGT9000 error bit interpretation
- Fixed IFD behavior during loss of communication with Vantage that would cause Vantage HDI/VDI to stop updating
- Fixed potential reset when the map is zoomed below 10nm around the dateline
- Fixed user waypoint synchronization in a dual IFD configuration after being loaded through maintenance mode
- Fixed maintenance mode "hang" when loading full software release
Improvements
- Enhanced enroute VNAV to be compatible with DFC-110
- Improved dimming bus behavior with respect to DimBus %
- Improved processing of holds received as part of a Foreflight flight plan
- Dismissed Startup Page on transition to airborne
- Reduced redundant messages from traffic sensors in the event log
IFD 5XX/4XX Software Version 10.3.2.2 introduces improvements to the following in AviOS10.3.2.2:
Bug fixes
- Fixed bug that prevented user waypoints with special characters in the name from being loaded
- Fixed display of FIS frequencies in the FSS frequency list
- Fixed known issues with interface to GFC autopilots
- Fixed GAMA 429 output to prevent the display of active waypoint from being delayed on Aspen PFD
- Fixed bug that allowed selection of an approach when every transition contained an RF leg
- Fixed computation of radial/distance user waypoint position when based on a fix with no mag var
- Fixed GPS Select discrete unexpectedly going invalid
- Fixed issues affecting the reliability of flight plan upload from ForeFlight
- Fixed annunciations when approaches have no LNAV minima
- Fixed display units on multi-engine fuel flow display
- Fixed flight plan depiction on the map for some SIDs
New features and improvements
- Added support for Vantage 12
- Improved VOR sensitivity of the radio
- Added support for Bluetooth LE keyboards
- Improved maintenance mode discrete I/O page
- Added ability to clear alerts via remote switch
- Added support for NVIS-enabled IFDs
- Added support for Aspen display of Enroute VNAV
General
- Added capability to retain Data/Plan/Map tab settings between power cycles
- Modified communication between units to show database mismatch, etc.
- Added support for displaying remote secondary weather frequencies
Aux
- Improved manual dimming control
- Improved user profile management
- Added "notices" to alert counts datablock
- Shared "system wide" user settings between IFDs
Map
- Added ability to create a user waypoint by touching the map
- Added ability to select direct-to waypoint from the map
- Added map layer for user waypoints
- Map tab setting is retained across power cycles
- Added map layer for comm airspace types (TMZ, RMZ, Mode C, CFZ, MBZ)
FMS
- Added aural chime for next leg alert
- Improved performance of GPS steering on approach
- Improved visual approach capability when paired with KFC225 autopilot
- Improved stored route management
- Routes shared on command
- Allow selection of the sort order (by age, route name, origin or destination)
- Enhanced display format
- Added "delete all" capability for user waypoints
*******
To check the current level of the IFD:
SYSTEM STATUS
The “Status” LSK is a multi-state LSK that provides access to the software status page, weather datalink status page (if datalink is installed and properly configured), GPS status page, and the IFD databases status page. Pressing the adjacent bezel key or touching the label soft key cycles through the various status pages.
Software Status Page
The “Software” selection will present the top-level software part number information and some system-level parameters which can be useful during service calls and IFD feature descriptions.

.jpg)