-
Audio Fail message on R9 IFD5000
This is an indication that is generated by the DFC100 autopilot computer. Essentially this fault means the DFC100 is unable to read/write to an internal memory component. This will not affect any of the operation of the auto pilot, but will cause the aural alerting to cease. The unit will need to come back to Avid…
-
How to get current R9 configuration data (must be at 9.3.0 or later)
Here are the steps to view the most recently loaded configuration: * Boot IFD in maintenance mode. * Press the Top and 3rd LSKs simultaneously (vulcan death grip) While holding those LSKs, a counter in the upper left will count down from 3. After the counter expires, press Proceed to enter "Technician Mode" …
-
How to download Technicians Logs in R9 IFD's
Technician Log Download Procedure There are two sets of logs that can be downloaded from the Release 9 IFDs. The Pilot Logs are downloaded from Maintenance Mode on the “Get Logs” tab. They contain flight information for reconstructing a flight including air data, AHRS data, GPS data, and engine data. The Techni…
-
DFC90/100 Servo Start Up Voltages - Cirrus and Piper
This should be tested using a variable DC power supply, connected as displayed in the image below: Once connected, begin at 0VDC and slowly increase voltage until the servo begins to respond. That will be your "start-up voltage." DFC90 Servo Start Up Voltages Roll Servo should be less than 3VDC Pitch Servo…
.jpg)