.jpg)
R9 Config tool
Avidyne Dealers will need to access the dealers website to retrieve the appropriate software config tool. Check the unit software level to determine the correct tool that is required: 9.4 9.3 9.2 9.1
R9 - Config settings
IFD5000i Before requesting a repair or Exchange for any blade from the R9 system, always record the config settings. When performing the software update to a new release: 1) record the config setting (see attachment) 2) perform the software update (service bulletin) 3) download the Config Tool for the software…
R9 IFD Coax Connection Locations
R9 IFD Coax Connection Locations
IFD-5000i R-9.4.1 NavData Updates
IFD-5000i R-9.4.1 NavData...... Do to the increased size of the Jeppesen NavData bases, Avidyne has updated the NavData Storage Location within the IFD-5000i R-9.4.1 Integrated Flight Displays. Prior to R-9.4.1 the NavData was stored on the smaller Memory Chip located on the main Airborne Computing Resource (AC…
How to get blade serial numbers off the R9 status page
How to get blade serial numbers off the R9 status page Use the .PDF in the attachments.
Audio Fail message on R9 IFD5000
This is an indication that is generated by the DFC100 autopilot computer. Essentially this fault means the DFC100 is unable to read/write to an internal memory component. This will not affect any of the operation of the auto pilot, but will cause the aural alerting to cease. The unit will need to come back to Avid…
How to get current R9 configuration data (must be at 9.3.0 or later)
Here are the steps to view the most recently loaded configuration: * Boot IFD in maintenance mode. * Press the Top and 3rd LSKs simultaneously (vulcan death grip) While holding those LSKs, a counter in the upper left will count down from 3. After the counter expires, press Proceed to enter "Technician Mode" …
