The Avidyne 700-00004-0XX, 700-00004-1XX, and 700-00030-0XX MFDs contain a 3-volt lithium battery that maintains CMOS memory on an internal processor board and __**should**__ be replaced after **_10 years_** of service, or when CMOS memory fails to retain configuration data, whichever occurs first. If the battery is b...
How to create CMAX Key Code and Download Jeppesen Charts through JDM **January 2022 - update** If the CMax key code has comma's (see below), this is invalid, use the AviUtility.exe attached to generate a valid CMax key code. ![][1] Charts for the EX5000 MFD's require a CMAX Key Code. Below information applies o...
![][1] [1]: https://hf-files-oregon.s3-us-west-2.amazonaws.com/hdpavidynesupport_kb_attachments/2019/11-11/48b8d7df-c2c8-43d4-9466-e3c8e9e8fe73/AVIONICS___31-62-01_EX-5000_MFD.jpg ...
![][1] [1]: https://hf-files-oregon.s3-us-west-2.amazonaws.com/hdpavidynesupport_kb_attachments/2019/11-11/d9edde14-0ba0-4fb9-934c-fc028db058c2/AVIONICS___31-62-03_EX-5000_MFD.jpg ...
![][1] [1]: https://hf-files-oregon.s3-us-west-2.amazonaws.com/hdpavidynesupport_kb_attachments/2019/11-11/46c38f28-5570-478c-9540-fc5d1af3b19e/AVIONICS___31-62-02_EX-5000_MFD.jpg ...
In a properly operating system the fuel totalizer information is indeed going to be far more accurate than resistive style fuel quantity probes. They are separate and independent functions. Whereas Fuel Quantity information is based on inputs from the wing probes to the DAU, Fuel Totalizer information is a computation...
% Power display on EX5000 MFD % Power--Indicates the calculated percent of maximum rated power currently being produced by the engine. For SIU equipped aircraft, Percent Power is calculated by the EX5000 based on engine RPM, manifold pressure, outside air temperature, and fuel flow. For DAU-equipped aircraft, the % ...
1. Go to "Trips" page 2. Locate "Display" button in upper RH portion of the MFD 3. Cycle the "Display" button until it says "Display Status" 4. Here you will find your XM radio ID#, along with your subscription service level, and signal strength 5. If signal strength and service level are both none, check the...
To change the Fuel quantity in the MFD, follow these steps: 1) power on the avionics 2) go into flight mode (accept the confirm messages) 3) using the knobs on the bottom of the unit, switch to the Aux tab 4) on the left side of the MFD you have 5 illuminated buttons; hold the top and third (L1 and L3) for approxim...